LEADER 02624nam  2200349   450 
001 996278273703316
005 20231207090130.0
010   $a0-7381-6865-3
035   $a(CKB)3780000000090110
035   $a(NjHacI)993780000000090110
035   $a(EXLCZ)993780000000090110
100   $a20231207d2010      uy             0
101 0 $aeng
135   $aur|||||||||||
181   $ctxt$2rdacontent
182   $cc$2rdamedia
183   $acr$2rdacarrier
200 10$aIEEE Std 1505-2010 (Revision of IEEE Std 1505-2006) $eIEEE Standard for Receiver Fixture Interface /$fIEEE
210  1$aNew York :$cIEEE,$d[2010]
215   $a1 online resource (153 pages)
330   $aA mechanical and electrical specification for implementing a common interoperable mechanical quick-disconnect interconnect system for use by industry for interfacing large numbers of electrical signals (digital, analog, RF, power, etc.) is provided. These large interface panels (receiver and fixture panels) are employed primarily in test systems between stimulus/measurement assets and a related unit-under-test (UUT), although any application involving high-density contacts requiring a quick disconnect interface could benefit. The receiver is a receptacle that is mounted to test system mates with multiple fixtures, which serve as the buffer between the UUT and automatic test equipment (ATE). Fixtures translate standard input/output (I/O) signal routing offered at the receiver to a wiring interface that directly connects to the UUT. These UUT interfaces can represent cable connectors, direct plug-in (printed circuit board edge connectors), sensor monitoring, or manual feedback from the test technician. The primary objectives of this standard are: (a) to establish interface standards that permit interchangeability of mechanical/electrical receiver/fixture/connector product assemblies from various manufacturers under an open architecture; and (b) to develop within this framework a defined set(s) of interconnecting connector and mechanical specifications that supports available, accepted, low-cost commercial technology to reduced dependence on proprietary designs and extend life-cycle availability.
517   $aIEEE Std 1505-2010 (Revision of IEEE Std 1505-2006): IEEE Standard for Receiver Fixture Interface
517   $aIEEE Std 1505-2010 
606   $aElectric connectors
615  0$aElectric connectors.
676   $a621.319
801  0$bNjHacI
801  1$bNjHacl
906   $aDOCUMENT
912   $a996278273703316
996   $aIEEE Std 1505-2010 (Revision of IEEE Std 1505-2006)$92580958
997   $aUNISA