LEADER 02119nam  2200385   450 
001 9910135756903321
005 20231206173730.0
010   $a0-7381-4138-0
035   $a(CKB)3780000000089141
035   $a(NjHacI)993780000000089141
035   $a(EXLCZ)993780000000089141
100   $a20231206d1989      uy             0
101 0 $aeng
135   $aur|||||||||||
181   $ctxt$2rdacontent
182   $cc$2rdamedia
183   $acr$2rdacarrier
200 10$aANSI/IEEE Std 1035-1989 $eIEEE recommended practice : test procedure for utility interconnected static power converters /$fIEEE Standards Board, American National Standards Institute
210  1$aNew York, NY :$cIEEE,$d1989.
215   $a1 online resource (26 pages) $cillustrations
330   $aThe following topics were dealt with: This test procedure is a recommended practice for testing utility-interconnected static power converters. The test procedure applies to single- and three-phase units rated from 1 kW to 500 kW and may also be applied in principle to larger units. The objective of this test procedure is the measurement of electrical parameters at the AC terminals of the power converter. The test procedure may serve as a basis for factory or acceptance testing. It focuses on equipment that lends itself to mass production and is readily interconnected to an electric utility, rather than on equipment subject to site-specific design and testing. Test results may be used in evaluating or comparing different types of static power converters.
517   $a1035-1989 - IEEE Recommended Practice
517   $aANSI/IEEE Std 1035-1989: IEEE Recommended Practice: Test Procedure for Utility-Interconnected Static Power Converters
606   $aElectric current converters
606   $aPower electronics$xStandards
615  0$aElectric current converters.
615  0$aPower electronics$xStandards.
676   $a621.313
712 02$aAmerican National Standards Institute,
801  0$bNjHacI
801  1$bNjHacl
906   $aDOCUMENT
912   $a9910135756903321
996   $aANSI$92072434
997   $aUNINA