3.1 Dynamic Modeling of Switched Reluctance Motor -- 3.2 Torque Sharing Function -- 3.3 SOGI-Based PR Controller -- 3.4 Short-Time Fourier Transform -- 3.5 Asymmetric Bridge Converter -- 4 Simulation Results and Discussion -- 5 Conclusion -- References -- Application of EWT for Analyzing Rotor Fault in Inverter Fed Induction Motor Using FEM -- 1 Introduction -- 2 Co-simulation and Fault Modeling -- 3 Speed and Phase Current Analysis of Healthy and Faulty Motor in FEM -- 4 Analysis of Phase Current Using EWT -- 5 Conclusion -- References -- Comparative Analysis of a Gradationally Controlled Voltage Inverter -- 1 Introduction -- 2 Gradationally Controlled Voltage Inverter -- 3 Operating Principle of a GCVI -- 3.1 Concept of Energy Transfer and Control -- 3.2 Ternary Gradationally Controlled Voltage Inverter -- 3.3 Techniques of Delivering Energy to Bit-Inverters -- 4 Simulation Results and Discussions -- 5 Comparative Analysis -- 6 Conclusion -- References -- Modified Non-isolated Bidirectional DC-DC Converter for Regenerative Braking for Electric Vehicle Applications -- 1 Introduction -- 2 Step-Up Mode of Modified Converter -- 2.1 Mode 1, [t0 , t1] -- 2.2 Mode 2, [ t1, t2] -- 2.3 Mode 3, [ t2, t3] -- 2.4 Mode 4, [ t3, t4] -- 3 Step-Down Mode of Modified Converter -- 3.1 Mode 1, [t0 , t1] -- 3.2 Mode 2, [t1 , t2] -- 3.3 Mode 3, [t2 , t3] -- 3.4 Mode 4, [t3 , t4] -- 4 Simulation Results -- 5 Experimental Results -- 6 Conclusion -- References -- Control Scheme for Active Power Decoupling in PWM Converter with Increased Power Density -- 1 Introduction -- 2 Active Power Decoupling -- 2.1 Calculation of Ripple Power -- 2.2 Principle of Active Decoupling -- 3 Power Circuit and Proposed Control System -- 4 Results and Discussion -- 4.1 Simulation Results -- 4.2 Processor-in-the-Loop (PIL) Results -- 5 Conclusion -- References. |